T28 Push-In Terminals for 0.062” diameter holes

Tools sold separately

T42-1

■  Wiring terminals for mounting leads or wires horizontally or vertically (through board hole)
■  Vertical (longitudinal) slot holes .025” diameter leads or 22 gauge wires
■  Includes .018” diameter tab hole which accepts transistor wires, can be used to hold anchoring wire
■  Material is phosphor bronze

■  Wire-wrap terminals installs in two .042” diameter holes on 0.1” centers
■  Short leg can be bent to secure pin
■  Long post can share hole with T42-1 Micro-Klip
■  Material is phosphor bronze​

T28

T42-1 with K32

Tools sold separately

K32

​​​T42-1 Push-In Terminals for 0.042” diameter holes

Push-In / Press-In   Terminals

​“J” pin, as accessory to the T42-1 Micro-Klip, has a long Wrap Post which can extend through the same hole in which the Micro-Klip is mounted. The “J” also serves to hold the “Klip” firmly in place when soldered. It may be staked to the mounting board by bending over the emergent short end of the “J”.

K32 "J"-Pin Terminals for 0.042” diameter holes

■  Wiring terminals for mounting leads or wires horizontally or vertically (through board hole)
■  Connectors require no staking for most applications
■  Horizontal slot holds up to seven wires, depending upon thickness of wire.
■  Phosphor Bronze

Tools sold separately